MRM32/UC110-240V
- 2 Changeover contacts
- Contact material AgNi
- Measuring range 0.1-480 V AC / 0.1-690 V DC / 0.1-5 A
- For installation in electrical distributor
- Monitoring: U, I, f, P, S, Cos ϕ, Δϕ
- Contact material AgNi
- Measuring range 0.1-480 V AC / 0.1-690 V DC / 0.1-5 A
- For installation in electrical distributor
- Monitoring: U, I, f, P, S, Cos ϕ, Δϕ
ELDAS®:
543951200
| Current type | AC / DC (50 Hz) |
|---|---|
| Nominal voltage | 110 V-240 V |
| Conductor cross section control / main circuit | 2.5 mm2 |
|---|---|
| Housing material | PC |
| Ingress Protection | IP 20 |
| Nominal screw torque control / main circuit | 0.6 |
| Operation temperature | -40 … 60 °C |
| Storage temperature (no ice) | -40 … 85 °C |
| Weight | 125 g |
| Overvoltage category | III |
|---|---|
| Pollution degree | 2 |
| Rated test voltage main / main circuit | 1.5 kV rms / 1 min |
| Rated test voltage main circuit / power supply | 2 kV rms / 1 min |
| Rated test voltage measuring / measuring circuit | 1.5 kV rms / 1 min |
| Rated test voltage measuring circuit / main circuit | 2 kV rms / 1 min |
| Rated test voltage measuring circuit / power supply | 2 kV rms / 1 min |
| Rated test voltage open contact | 1.5 kV rms / 1 min |
| Contact materials | AgNi |
|---|---|
| Mechanical endurance (cycles) | 30 000 000 |
| Minimum load | 10 mA, 10 V |
| Number of contacts | 2 CO |
| Rated current | 6 A |
| Rated load AC-1 | 1250 VA |
| Rated voltage | 250 V AC |
| AC voltage measurement range L-N / L-L | 0.1 … 480 V |
|---|---|
| Alarm delay | 0.5 … 999.9 s |
| Alarm reset delay | 0.5 … 999.9 s |
| DC voltage measurement range U+ / U- | +0.1 … +690 V, -0.1 … -690 V |
| Measured parameters | U, I, P, S, f, Cosϕ, ΔPhi, phase sequence |
| Measurement current range | 0.1 … 5 A |
| Min. setting step, resolution | 0.1 V / 0.1 A / 1 W / 1 VA / 1 Hz / 0.05 / 1° |
| Monitoring functions | Under, over, inside, outside, phase sequence, phase failure |
| Number of current measurement inputs | 3 |
| Number of voltage measurement inputs | 3 |
| Overcurrent threshold Ith setting range | 0.1 … 6 A |
| Overvoltage setting range | +0.1 … +700 V, -0.1 … -700 V |
| Rated AC voltage L-N / L-L | 230 V / 400 V |
| Rated base frequency | 15 … 150 Hz |
| Rated DC voltage U+ / U- | 300 |
| Rated measurement current | 5 |
| Undercurrent setting range | 0.1 … 6 A |
| Undervoltage setting range | +0.1 … +700 V, -0.1 … -700 V |
| Frequency range | 16 … 63 Hz |
|---|---|
| Nominal voltage | 110 … 240 V UC |
| Operating voltage range | 85 … 250 V |
| Power consumption AC / DC | 2.6 VA / 1.5 W |
| Approvals | UKCA,CE,cULus,EAC |
|---|---|
| Standards | EN 60947-1,EN 60730-1,EN 61000-6-3,EN 61000-6-2 |
Approvals
3D-models "MRM32/UC110-240V"
Documents "MRM32/UC110-240V"